After-sales service:0769-83223165;Sales consulting:13829221685
How to change turret milling machine screw?

Category:How to change turret milling machine screw?

Summary:Turret milling machine in use for a long time, there will be screw shaking, or the need to replace a screw without precision, but a lot of people also understand where the problem with the milling machine, but it will not be replaced. Opera

Inquiry: 138-2922-1685  13712336185

Click here to send me a message

This product has been viewed Time

The detailed information

Turret milling machine in use for a long time, there will be screw shaking, or the need to replace a screw without precision, but a lot of people also understand where the problem with the milling machine, but it will not be replaced. Operation of the milling machine master want to change, but will not change, so only to find a professional maintenance master to change a screw, and delay time, and not economic, dongguan city real CNC technology teach you to change turret milling screw.
 
The suspension beam of the turret milling machine is installed in the upper part of the guide rail of the bed body. To meet the processing needs. The spindle gearbox inside the suspension beam is first transferred by the motor through a series of gears and then to a pair of bevel gears, and finally drives the milling head spindle out. High and low speed reversing should be used in conjunction with clutch handle. When selecting high speed, the clutch handle should be moved to the spindle brake handle, and the high and low speed changing handle should be put on the right side to the clutch. The front and rear direction of the Y axis table along the guide rail of the turntable to drive the workpiece fixed on the table for longitudinal feed motion. If the handle to the high speed position, and the clutch does not enter the match, do not forcibly pull the handle, you can use the hand rotation spindle front straight spindle brake handle to brake the spindle in either direction. In order to avoid the local wear of the worktable, the screw should be changed as often as possible on the clamping position of the workpiece on the worktable.

The latest information

Copyright©2013-2014  Dongguan xinda ultrasonic equipment co. LTD  All rights reserved For the record,ICP 07506421 | Fax :(0769) - | tel: (0769) -83223165 |hjt@dg-xd.com |